-
Your shopping cart is empty!
EVERYTHING ELSE
IAC MP to F-WP Adapter
- IAC MP to F-WP AdapterThis adapter converts your early GM wiring harness plug to the late model IAC ..
IAC Relocator - 84/89
- IAC Relocator - 84/89This wiring kit allows you to extend the terminals on an IAC motor, by plugging..
IAC Splice - 84/89
- IAC Splice - 84/89 Replacement for the IAC connector, frequently found with a broken latch. Located..
Injector Con. Kit (Marine)
- Injector Con. Kit (Marine)This kit contains four injector connectors with seals and terminals. Used ..
Injector Connector Kit EV1
- Injector Connector Kit EV1This kit contains four injector connectors with seals and terminals. Used ..
Injector Harness 8.1L (EV1 INJECTORS)
- Injector Harness 8.1L (EV1 INJECTORS)CHECK YOUR CONNECTOR ENDS!..
Injector Harness Car Side Pair - 84/85
- Injector Harness Car Side Pair - 84/85This pair of TWR connectors, both 3 and 4 cavity Weatherpack, ..
Injector Harness Engine Side Splice - 1986 / 1989
- Injector Harness Engine Side Splice - 1986 / 1989 A common failure due to heat drying out the plas..
Injector Harness Intake Side Splice - 1986 / 1989
- Injector Harness Intake Side Splice - 1986 / 1989Female 7 cavity connector with male pins as used on..
Knock Gauge Rev3
- Knock Gauge - rev3Black Face / Black TrimDetonation is your worst enemy and is the main cause of a b..
Knock Sensor Splice - 84/89
- Knock Sensor Splice - 84/89Found under coil module, single cavity oval connector, blue wire. Plugs i..
Knock/Cam Harrness LS1 to LS2/LS7
- Knock/Cam Harrness LS1 tlo LS2/LS7 All in one!Cam HarnessThis harness allows the cam sensor used on ..
Late Model F-Body - LS1 Fuel Pump Hotwire Kit - NOT FOR 1998 LS1
- Late Model F-Body - LS1 Fuel Pump Hotwire Kit 1999 AND ON - NOTE: Not for 1998 F-body or LS1 applic..
Lo Speed Fan Relay Connector Splice
- Lo Speed Fan Relay Connector SpliceReplaces LOW speed fan relay connector, drivers side inner fender..
LS1 MAF to 3800 MAF Pigtail
- LS1 MAF to 3800 MAF PigtailOur 108099 Plug-in adapter is designed to adapt the current LS1 5-wire Ma..
LS1 MAP Extension 26"
- LS1 MAP Extension 26" This harness is used to extend the MAP sensor on any LS1 or LS2 based engine...
LS2 TO LS1 Throttle Body Adapter Harness
- LS2 TO LS1 Throttle Body Adapter HarnessNOTE: THIS HARNESS IS DESIGNED TO WORK WITH TBs THAT ARE 200..
LT1 MAF Splice
- LT1 MAF Splice..
MAF IAT break out (GM, C7)
- 109181 This IAT Break out is for a GM 8 wire MAF. Works with: C7 GM trucks..
MAF Adapter 3 pin w/ IAT to GT
- MAF Adapter 3 pin w/ IAT to GTDesigned to facilitate the installation of a 5 wire WIDE pin spaced MA..
MAF Adapter Hi-Density Small 5 pin to GT
- MAF Adapter Hi-Density Small 5 pin to GT INSTALLATIONin PDF format..
MAF Extension 12"
- MAF Extension 12" Relocating or installing upgrade or accessory devices, such as Airfuel Ratio gaug..
MAF Extension 24"
- MAF Extension 24" Relocating or installing upgrade or accessory devices, such as Airfuel Ratio gaug..
MAF Extension 36"
- MAF Extension 36" Relocating or installing upgrade or accessory devices, such as Airfuel Ratio gaug..